Blind rivet nuts · Steel
Steel Flange Head Knurled Body Rivet Nuts — Closed End
This steel blind rivet nut is listed with a flange head, knurled body and closed end. The closed-end form requires attention to usable thread depth and screw length, in addition to the panel thickness and receiving hole.

Product configuration
- Head
- Flange head
- Body
- Knurled body
- End form
- Closed end
- Material
- Steel
- Thread references
- M3, M4, M5, M6, M8, M10
Catalogue thread references: M3, M4, M5, M6, M8 and M10. Confirm dimensions and grip range for the chosen part; the thread list is not a stock statement.
Check the closed-end clearance
Provide the required usable thread depth and the mating screw length, allowing for the full assembly stack. The screw must fit the selected part without bottoming out. Include the body length, hole diameter and tolerance, grip range and available space behind the panel in the drawing review.
Specify steel and any sealing requirement separately
Give the required steel grade and finish rather than relying on a generic Steel designation. If the application needs a defined sealing performance, state the seal arrangement and test requirement for review. A closed end by itself is not a verified sealing rating for the assembled joint.
Include with your RFQ
- Thread size, pitch and usable thread depth
- Screw length and total assembly stack
- Round hole dimensions, sheet thickness and grip range
- Closed-end body length and rear clearance
- Steel grade, finish, inspection requirements and quantity
Attach the part or assembly drawing and identify any installation or acceptance requirements. Use the enquiry form below to send the selected configuration.